Tips on Fixing Pool Tiles

Posted on 17 January 2013

Facing troubles with the tiles of the areas surrounding your pool is a common problem with most of you. There are times when you may face shifts as well as minor or major cracks in the tiles. At times, you may also find that the mortar holding of the pool has loosened. This may be a major cause for your tiles to crack or pop up. However, whatever the reason might be, the tiles look shabby when it cracks. It is quite natural on your part to get infuriated in such a situation but you should not jump your gun down. There are ways to fix the trouble that you face with improper tile installation in your pool area. Fixing Pool Tiles

Consider taking a thorough look at the ways which are suggested below. 

Take care of falling off tiles 

In some cases, you might see that the tiles are falling off. If this kind of a trouble takes place in your pool area, you have to sense that there might be some horizontal cracks at the back of the tiles. The problem might also be the outcome of a bond failure in the mud, which was used at the time of getting the tiles installed. In order to get rid of this kind of a trouble in your pool tiles you are going to find temporary re-grouting useful. At the same time, you can also consider caulking the joints as well as popped up sections. When you start the job of repairing, you should make it a point that you are going to use water proof grouts as well as thin set mortars.

Get the tiles cured of white deposits 

White deposits are quite common problems with pool tiles. The deposits are also known as efflorescence. These white deposits appear on the surface of pool tiles when mineral salts like magnesium as well as calcium start emitting from the grouts. To take care of this problem you have to use the procedure of acid wash on the tiles. 

Use additive mixed plasters 

When you fix the damaged pool tiles, you should keep it in mind that you need to mix up additives with the plaster. Mixing of additives is highly important as it is going to increase the consistency level of the plaster. You are also at the liberty of mixing up water with the plaster as well but should not go overboard while adding water. By adding too much of water into the mixture you are actually going to weaken it.

Make it a point that you are going to follow the tips, which have been shared with you here. However you should keep it in mind that you might not have the time or the experience to execute the suggested ways into actions. It is evident that you need to talk to some seasoned tile contractors so that you can choose a reliable pro to fix the troubles.  It is only possible for a skilled pro to take proper care of the situation, mend the problem and give a surprising make over to the pool area of your house.

Hope you found the suggestions beneficial. Keep reading our blogs to make your home a better place to live in.

You might also like this:

Leave a Reply

Your email address will not be published. Required fields are marked *

*


*